Specifications:

Rated power, VA

33000 (3*11000)

Maximum current (in one phase), A

50

Input voltage range (in one phase), V

120 - 285

Output voltage range (in one phase), V

220+/- 8%

Stabilization type

relay

Accuracy output voltage,%

8

Adjustment

stepwise

Distortion sine wave

no

Operating range t ° C

-30 - +50

Cooling

forced

Network Connection Method

terminal block

Housing

metal

Protection against short circuit

+

Lightning protection

+

Dimensions (one stabilizer), cm

43x28x18

Weight (one stabilizer), kg

19

Installing a voltage stabilizer for each phase (in the absence of a three-phase load in a three-phase network) will avoid the situation of voltage loss in all three phases (unlike a three-phase stabilizer).

An advantageous offer for those who want to optimally protect their equipment and at the same time save their finances (when buying a kit, a significant discount). Such a kit will allow you to put protection on every important device or you can use it in a three-phase network.

Installation voltage stabilazer in a three-phase network for each phase will provide 33 kVA of power, and thereby eliminate the possibility of complete loss of the network. When connecting a three-phase load (machines, motors, etc.), it is enough to additionally install a phase control relay.

Distinctive features:

Universal metal housing (mounted and outdoor)
Holtek HT46R47 Microcontroller
Digital display
Bypass
Wide operating range (120-285 Volts)
Instantaneous response time to changes in input voltage
High stabilization accuracy (up to 5%)
Automatic delay (3 seconds)
Analysis of input voltage at any time
Analysis of the boundaries of the working range
Short circuit protection
Overload protection (overheating)
Undervoltage protection
Over-voltage protection
Protection against pulse (lightning) discharges

Dimensions of one stabilizer:

Length X Width X Height - 43x28x18 sm
Weight - 19 kg

Connection

The connection of SUNTEK single-phase stabilizers to the three-phase network is carried out strictly according to the scheme.

It is important to know when installing SUNTEK single-phase voltage stabilizers in a three-phase network:

It is impossible to connect single-phase voltage stabilizers to a three-phase network if there is a three-phase load powered by 380 volts and there is no protective disconnection device (phase lock device). If three-phase devices will not be connected to the network, then the installation of single-phase stabilizers is quite possible.

When choosing a nominal value, it should be understood that if a three-phase voltage is supplied to you, for example, 15,000 VA, respectively, it is 5000VA for each phase. We recommend installing models 8500VA and higher in a three-phase network.